Data Sheet for Product

Technical Specification Sheet
Document No. 149-492
June 22, 2016
Siemens Digital
Point Pickup Module
The Siemens Digital Point Pickup Module (PPM) is a
slave I/O device that communicates on a P1 FLN or
expansion bus. The PPM allows primarily digital point
expansion for any APOGEE field panel that has P1
FLN or expansion bus capabilities.
Features
• 1 AI/DI (configurable to 10KΩ Type II NTC
thermistor analog input or dry contact digital input
via a slide switch), 3 dry contact digital inputs and
2 digital outputs. Total of 6 available points.
• Default communication at 4800 baud also supports
9600, 19200, 38400, 57600 and 115200 via auto-
detect.
• 8-bit DIP switch to configure address
• Recover and resume communication on the
network after a power interruption without operator
intervention.
• Capable of mounting on various electrical junction
boxes without field modification or adaptors.
− 4 in. x 4 in. standard depth US box, 100 mm x
100 mm x 25 mm Asia/Pacific standard box,
86 mm x 86 mm x 25 mm China standard box.
• Plenum rated, no enclosure necessary.
• A removable barrier is integrated into the
packaging to keep high voltage wiring separate
from low voltage wiring within the junction box
• LEDs visible through the housing, indicate the
power, communication, and DO status.
• Assembly has a cover label associated with the
LEDs for easy labeling.
• No calibration required, thereby reducing
maintenance costs.
• Optional DIN Kit for mounting PPM on a DIN rail
(PPM-DINKIT) sold separately.
Hardware
Controller Board
The controller interfaces with but does not provide
direct control of the following external devices:
• Temperature sensors (room, duct, immersion, and
outside air) 10KΩ Type II NTC
• Digital input devices (dry contacts from motion
sensors, alarm contacts) or LPACI
• Digital output devices (fans, pumps, stages of
electric heat)
Siemens Building Technologies, Inc.
Page 1 of 2