User Manual

Ordering
Please specify the quantity (Min. 60), product name, ASN and SSN as follows.
Quantity
Product name
ASN
SSN
60
HMI-LED
POL831.25/STD
S55626-H312-F100
Engineering notes
The HMI-LED is powered by the connected controller via RJ45 connector (low
voltage, SELV). It must be connected to controller POL4XX or POL6XX using a
standard network cable (not part of the delivery).
Installation
The HMI-LED must be mounted on the control cabinet with easy clip fastened. See
Dimensions on page 7 for the hole size.
Observe all local installation regulations.
The equipment is not protected against accidental connection to AC 230 V.
Commissioning
As soon as the HMI-LED is connected to the controller via RJ45 connector, the
parameter initialization restarts. If one parameter can’t receive a response, the next
request is delayed for 5 seconds to avoid flood frame on the bus.
Disposal
The devices are considered electronics devices for disposal in term of European
Directive 2012/19/EU and may not be disposed of as domestic waste.
• Dispose of the device via the channels provided for this purpose.
•
Comply with all local and currently applicable laws and regulations.
STOP
5 / 8
Siemens HMI-LED CB1Q3946en
Building Technologies 2016-03-25