Operating instructions

Operation and configuration
9.1 Normal operation
SIMATIC Panel PC 677B
Operating Instructions, 05/2007, A5E01035609-01
67
Operation and configuration
9
9.1 Normal operation
9.1.1 Switching on the device
Requirement
● The peripheral devices are connected.
Caution
To comply with the EMC guideline of the device with I/O, ensure that the manufacturer
or supplier of the components used guarantees compliance with the regulations.
Connect the I/O devices via shielded cables with metal connectors. In doing so, the
shield must be connected over a wide area with the metal connector and the connector
must be firmly connected with the device housing.
● The operating system and the service packs have been installed and set up on the hard
disk of the device. Refer to the "Commissioning" chapter for more information.
● The pre-installed drivers and applications have been set up appropriately. Further
information is available in the "Operation and configuration" chapter in the section,
"Additional drivers and applications."
● The proper ambient and environmental conditions according to the specifications for the
device and the connected I/O modules have been observed.