Operating instructions
Detailed descriptions
17.4 BIOS Setup
SIMATIC Panel PC 677B
218 Operating Instructions, 05/2007, A5E01035609-01
SATA Port 0, SATA Port 1, SATA Port 2, SATA Port 3
The system jumps to the following submenu when you select this type of menu field:
6$7$3RUW >0%@
3KRHQL[%,266HWXS8WLOLW\
,WHP6SHFLILF+HOS
7\SH
(6& ([LW
6HOHFW,WHP
6HOHFW0HQX
6HOHFW
&KDQJH9DOXHV
6XE0HQX
)
)
6HWXS'HIDXOWV
6DYHDQG([LW
(QWHU
+HOS
)
0DLQ
>$XWR@
/%$)RUPDW
7RWDO6HFWRUV
0%0D[LPXP&DSDFLW\
0XOWL6HFWRU7UDQVIHUV
/%$0RGH&RQWURO
7UDQVIHU0RGH
8OWUD'0$0RGH
8VHU \RXHQWHU
SDUDPHWHUVRIKDUGGLVN
GULYHLQVWDOOHGDWWKLV
FRQQHFWLRQ
$XWR DXWRW\SHV
KDUGGLVNGULYH
LQVWDOOHGKHUH
&'520 &'520GULYH
LVLQVWDOOHGKHUH
$7$3,5HPRYDEOH
UHPRYDEOHGLVNGULYHLV
LQVWDOOHGKHUH
>6HFWRUV@
>(QDEOHG@
>)3,2'0$@
>0RGH@
%LW,2
>'LVDEOHG@
Figure 17-8 SATA Port 0 (example)
[User] Select “User” to enter a user-specific definition of the hard disk
type. Configure all the other options, for example, Cylinder, Heads,
Sectors/Track, or other properties of the hard disk drive.
[Auto] The parameters which you can select in this dialog are usually
saved to the respective IDE drive. The "Auto" setting in the "Type"
field means that these values are automatically read from the drive
and written to memory.
If Type is selected for a drive that does not exist, a timeout is
triggered within approximately 1 minute and the entries remain
unchanged. It makes sense only to set "Auto" for interfaces to
which a drive is connected.
[CD/DVD-ROM] CD/DVD-ROM is connected
[ATAPI
Removable]
A removable data volume is connected
Type
[None] Select "None" if you have not connected a disk drive. This setting
reduces system waiting time.
The number of blocks (sectors) transferred per interrupt are defined at the "Multi-
Sector Transfer" option. The value depends on the drive and should only be set by
way of "Auto" setting at the "Type" field.
Multi-Sector
Transfer
Disabled 2, 4, 8, 16 sectors