Technical data

Configuring the Computing Unit
5-5
SIMATIC Panel PC 670 Computing Unit Equipment Manual
Edition 12/01
System Time and System Date Time and date
System Time and System Date display the current values. Once you have
selected the appropriate box, you can use the + and – keys to modify the
Hour:Minute:Second and Month/Day/Year settings.
You can move between the entries in the System Time and System Date boxes
(for example, from Hour to Minute) using the tabulator key.
Diskette A Disk drive
Here you set the type of floppy disk drive installed on the computing unit. The
following entries are possible:
[Disabled] If there is no disk drive or LS 120 drive. Default setting for an installed
LS 120 drive.
[360 KB,5 1/4”]
[1.2 MB,5 1/4”]
[720 KB,3 1/2”]
[1.44 MB, 3 1/2”] Default setting for an installed disk drive A
[2.88 MB, 3 1/2”]
Primary Master, Primary Slave, Secondary Master, Secondary Slave
The system goes to the following submenu, for example, when you select one of
these menu options:
PhoenixBIOS Setup Utility
Item Specific Help
ESC EXIT
Select Item
Select Menu
+ / –
Enter Select
Change Values F9
F10
Setup Defaults
Save and Exit
Sub-Menu
Type:
Cylinders:
[Auto]
Heads:
Total Sectors
Maximum Capacity
Main
Primary Master [4326MB]
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
[8940]
[ 15]
[8448300]
4326MB
[16 Sectors]
[Enabled]
[Enabled]
[FPIO 4 / DMA 2]
Ultra DMA Mode:
[Disabled]
[AUTO] (recommended)
Autotypes installed
IDE-devices
[USER]
Enter parameters of
IDE-devices installed
at this connection
F1 Help
Figure 5-3 Example: Primary Master