Technical data

Configuring the Computing Unit
5-28
SIMATIC Panel PC 670 Computing Unit Equipment Manual
Edition 12/01
System Parameters Your EntriesStandard Settings
Internal COM2 Enabled
Base I/O address 2F8
Interrupt IRQ3
Internal LPT1 Enabled
Mode Bi-directional
Base I/O address 378
Interrupt IRQ7
DMA Channel (for ECP only) DMA 10
PCI Configuration
PCI Device Slot 1
Option ROM Scan Enabled
Enable Master Enabled
Latency Timer 0040 h
PCI Device Slot 2
Option ROM Scan Enabled
Enable Master Enabled
Latency Timer 0040 h
on board PCI Ethernet
Option ROM Scan Disabled
Enable Master Disabled
Latency Timer 0040 h
PCI/PnP ISA IRQ Exclusuion
IRQ3 Available
IRQ4 Available
IRQ5 Available
IRQ9 Available
IRQ10 Available
IRQ11 Reserved
PCI IRQ Line 1 Auto Select
PCI IRQ Line 2 Auto Select
PCI IRQ Line 3 Auto Select
PCI IRQ Line 4 Auto Select
Installed O/S Other
Reset Configuration Data No
Floppy disk controller Enabled
Local Bus IDE adapter Primary& Secondary
Large Disk Access Mode DOS
Hard Disk Pre-Delay Disabled
Memory Gap at 15 MByte Disabled
Security
Supervisor Password is Disabled
User Password is Disabled
Set Supervisor Password F0 5A
Set User Password F0 5A
Password on boot Disabled