User's Manual

Appendix
A.3 List of abbreviations
A.3 List of abbreviations
abs.
WMS
Absolute angular position measuring system, absolute encoder
BGR Health and safety at work regulations (in Germany)
BGV Binding national health and safety at work regulations (in Germany)
CE Communauté Européenne (European Community)
DAC Digital-to-analog converter
DIN Deutsches Institut für Normung (German standards organization)
DQ DRIVE-CLiQ
EU European Union
EMF Electromotive force
EMC Electromagnetic compatibility
EN Europäische Norm (European standard)
EEC European Economic Community
FAQ Frequently asked questions
HFD High-frequency damping
HW Hardware
IATA International Air Transport Association
IEC International Electrotechnical Commission
Incr.
WMS
Incremental angular position measuring system, incremental encoder
IP International Protection
K
V
factor Proportional gain
KTY Temperature sensor with progressive, almost linear characteristic
MLFB Maschinenlesbare Fabrikatebezeichnung (order designation)
LI Line infeed
NC Numerical control
NCK Numerical control kernel: NC kernel with block preparation, travel range, etc.
PE Protective earth
PELV Protective extra low voltage
PDS Power drive system
ph value Concentration of hydrogen ions in a liquid
PLC Programmable logic controller
PTC Temperature sensor with positive temperature coefficients and "quasi-switching"
characteristic
RLI Rotor position identification ("pole position identification"); procedure for
determining the commutation angle offset
S1 "Continuous operation" mode
S2 "Short-time operation" mode
S3 "Intermittent operation" mode
SME Sensor Module External
1FW6 Built-in torque motors
296 Configuration Manual, 05/2009, 6SN1197-0AE00-0BP3