Operation Manual

Using Other Functions
75
Step by Step
• Send a message,
code:
*
68/#68 Æ page 67
• Leave an advisory message,
code:
*
69/#69 Æ page 68
• Group ringing, code:
*
81/#81 Æ page 88
• Group call, code:
*
85/#85 Æ page 88
• Suppress caller ID,
code:
*
86/#86 Æ page 28
• Waiting tone, code:
*
87/#87 Æ page 17
• Open door, code:
*
61 Æ page 23
• Door opener on/off, code:
*
89/#89 Æ page 24
• Control relay, code:
*
90/#90 Æ page 78
• Do not disturb, code:
*
97/#97 Æ page 21
• Ringer cutoff function, code:
*
98/#98 Æ page 21
• Speed-dialing, code:
*
7 Æ page 43
• Associated service, code:
*
83 Æ page 73
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
D
Set up a call to the system. Enter the station number
(contact your service personnel).
D
Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
G
Enter the code (necessary only if programmed in the
system).
D
Wait for a dial tone and then enter the code, such as
*
97 for Do not disturb on. Make other inputs as neces-
sary; (refer to the operating instructions for pulse and
DTMF telephones).
or
D
Dial the external number.
You can only execute one function at a time, or
set up only one outgoing connection.
The connection is immediately released after
successful activation of a function.
In the case of an external-external call, the con-
nection is released as soon as either of the par-
ties ends the call.