Operating instructions

Using Other Functions
93
Step by Step
Using System Functions
from the Outside (DISA: Direct Inward
System Access)
If this function has been configured (contact your ser-
vice personnel), you can set up external outgoing calls
from outside the system, just like an internal user. You
can also activate and deactivate the following functions
in your system:
• Reset services and functions,
code #0 Æ page 89
• Call forwarding, code:
*
1/#1 Æ page 76
• Locking and unlocking telephone,
code:
*
66/#66 Æ page 64
•Save PIN,
code:
*
93 Æ page 65
• Send a message,
code:
*
68/#68 Æ page 82
• Leave an advisory message,
code:
*
69/#69 Æ page 84
• Group ringing, code:
*
81/#81 Æ page 106
• Group call, code:
*
85/#85 Æ page 106
• Suppress caller ID,
code:
*
86/#86 Æ page 35
• Waiting tone, code:
*
87/#87 Æ page 24
• Open door, code:
*
61 Æ page 30
• Door opener on/off, code:
*
89/#89 Æ page 31
• Control relay, code
*
90/#90 Æ page 97
• Do not disturb, code:
*
97/#97 Æ page 27
• Ringer cutoff function, code:
*
98/#98 Æ page 28
• Speed-dialing, code:
*
7 Æ page 55
• Associated service, code:
*
83 Æ page 91
Precondition: You have a telephone that uses tone di-
aling (DTMF dialing) or you can switch your telephone
to tone dialing. The telephone is not connected to the
system.
o Set up a call to the system. Enter the station number
(contact your service personnel).
o Wait for a continuous tone (if necessary switch the tele-
phone to tone dialing), then enter the internal number
that has been assigned to you and the associated PIN.
r Enter the code (necessary only if programmed in the
system).