Technical data

Command Line Interface CLI at HG 3500

EN4442EN00EN_0001

Siemens

show fingerprint

Before accepting a certificate warning in the browser, it is strongly recommended that the

administrator should compare the fingerprint of the certificate displayed in the browser

against the fingerprint shown in CLI. The certificate must be accepted only, if both

fingerprints are identical!

ip address

The parameter <ip address> is a string in the form of x.x.x.x and x is an integer (e.g. 1.2.3.4).

hostname

The parameter < hostname > terms an arbitrary name for the gateway and it must be a string

of characters ( e.g. set hostname Gateway1 ). It corresponds with the boot line parameter

“targetname“.

ip subnet mask

The parameter < ip subnet mask > is a string in the form of x.x.x.x and x is an integer

between 0 and 255 (e.g. 255.255.255.224).

7.8 Changing the Login and Password for CLI

From HiPath 4000 V4 onwards for CLI login, the same accounts as for WBM login have to be

used. The accounts can be set up and changed via AMO CGWB. The parameter ROLE defines

the access rights.

CHANGE-STMIB:MTYPE=CGW,LTU=<ltu>,SLOT=<slot>,TYPE=WBMDATA,LOGINWBM=<user

of the wbm user>;

The initial login as ENGR is

username: HP4K-DEVEL

Passowrd: Siemens2000

After successful login the following message appears:

Welcome to the HG 3575 V4.0 <LW-version> Command Line Interpreter.

vxTarget>

As of HiPath 4000 V4, CLI is not released in two stages anymore!