Technical data

Command Line Interface CLI at HG 3500
EN4442EN00EN_0001
© 2007 Siemens AG
Siemens
42
show if counters
● To list all existing interfaces:
show interfaces
● To get admin and operating states:
show if states
Ping and tracert
● Diagnosis Commands:
ping <ip address>
Target shell
● vxWorks shell logon/logout:
shell
exit
Gateway Reboot
From the administrator point of view two different ways of a reboot command are of interest. At
first there is the need to reboot the gateway with the current configuration. On the other side
there could be the need to support a configuration data exchange, i.e. to take a configuration
data file from extern or to skip the latest configuration data storage and take the next older one.
It is in the responsibility of the administrator to coordinate a gateway reboot!
● Normal reboot of the gateway, using the current configuration data:
reset
● Reset any configuration data to factory defaults and reboot:
reset factory
● Special reboot of the gateway using an existing self-extracting image in order to complete
a software download:
activate software
7.7 SSL for WBM
SSL for WBM (i.e. https) is enabled in the factory delivered status. It cannot be disabled.
To permit a basic configuration of SSL following commands are needed.
● Display the fingerprint of the currently active certificate for WBM access via https.