Technical data

Command Line Interface CLI at HG 3500
EN4442EN00EN_0001
© 2007 Siemens AG
Siemens
40
7.3 Access control
● The configuration write access has to be acquired before a store, upload or download
command can be done. Because of the implemented “soft lock“ handling, at first a check
if somebody else has set the write access is required.
who has write access
get write access
release write access
7.4 Gateway Setup
To permit system initialisation and basic management configuration activities following
commands are needed.
● Setting and changing the gateway name:
set hostname <hostname>
● Setting and changing the IP-Address for the ethernet port:
set ip address <ip address>
set ip subnet <ip subnet mask>
A set or a change of the IP-address or IP subnet for the ethernet port will probably require
a gateway reboot to become effective.
● Setting and changing the IP-address of the default gateway from static routes table:
set default gateway <ip address>
● Display/change choosen identifier:
get id <parameter name>
set id <parameter name>
7.5 Image/File Handling
In common gateway software configuration and distribution as well as upload and download of
configuration data via CLI is not required because it is done via WBM.
Additionally operations for analysing event and trace data are supported.
The trace /event logs are available as:
/trace/trace.txt
/trace/trace.bak