Technical data

Command Line Interface CLI at HG 3500

EN4442EN00EN_0001

Siemens

7 Command Line Interface CLI at HG 3500

7.1 General Information

The common gateway supports a Command Line Interface (CLI) for installation and basic

configuration, e.g. IP infrastructure. In V.24 CLI it is possible to change security relevant data

(e.g. SSL Configuration), because the V.24 is considered to be secure. Additionally the CLI

allows the monitoring of important counters and statistics.

The CLI can be accessed via V.24. The CLI can not be accessed via Telnet because it is an

unsecure protocol.

To get an overview of the commands type in the command help and you get an alphabetic list

of all commands.

The basic facilities of the CLI are described below. In the following sections the CLI commands

are divided into six command type groups:

● General Operations

● Access control

● Gateway Setup

● Image/File Handling

● Maintenance

● SSL for WBM

7.2 General Operations

When starting a session the administrator is asked for authentication. That is done by entering

the admin name and the password.

● To leave the session use the

logout

command.

● The list of all supported commands except the hidden commands can be obtained with:

help