Technical data

Configuration Common Gateway

EN4442EN00EN_0002

Siemens

You can check the status with DISPLAY-BFDAT:FCTBLK=<number>;

If the configuration of the functional block is complete STATUS=OK is displayed.

If a configuration error is detected when the block configuration is complete, the functional

block must be deleted (DELETE-BFDAT:FCTBLK=<number>,ANSW=YES;) and reconfig-

ured.

If the configuration of a functional block is not complete STATUS=CONT is displayed. The

functional block may not be assigned to a board. This is refused by the AMO BCSU with

the Fault message F89.

Fault message F89

H500: AMO BCSU STARTED

F89: THE GIVEN FUNCTIONAL BLOCK IS NOT COMPLETELY CONFIGURED.

PLEASE FINISH CONFIGURATION BY MEANS OF AMO_BFDAT FIRST.

AMO-BCSU -54 BOARD CONFIGURATION, SWITCHING UNIT

ADD NOT COMPLETED;

5.3 Restrictions

● Only one trunking protocol can be configured for each board (AMO CGWB). There are no

restrictions on interworking with other functions.

● The entire board must be reconfigured if the changes are made to the configuration.