Technical data

Configuration Common Gateway

EN4442EN00EN_0002

Siemens

● For HFA and SIP, the number of circuits (LINECNT) and the number of B channels (BCHL-

CNT) must be specified.

● For WAML, only the number of units (UNITS) must be specified.

● Reserve function

Since the board configuration can only be modified by removing the board, an option has

been created that allows users to reserve circuits for use at a later stage. If this feature is

to be used for the functions HG3530, HG3540 or HG3550, the relevant function must be

configured directly after the actual function (HG3550&HG3550R, for instance). The Re-

serve function must always be specified after the actual function (i.e. at the end).

The combination HG3550&HG3530&HG3550R is not permitted as this would lead to in-

valid circuit distribution (Trunk - HFA - Trunk).

It is not possible to configure several Reserve functions on a single board.

The reserved circuits can be subsequently converted to usable circuits with

CHANGE-BCSU:TYPE=IPGW,LTU=<LTU>,SLOT=<slot>,CHNGRSLN=<number>;

/*<number>: Number of circuits that should be converted to usable

circuits.

● The STANDBY function can only be configured as a single feature.

● Twelve single feature standard profiles were created (see Chapter 9, “Single Feature Stan-

dard Profile for HG 3500 V4”). These can be assigned with the AMO BFDAT.

● You can configure a functional block with

CHANGE-BFDAT:CONFIG=OK,FCTBLK=<number>,ANSW=YES;

If reserved HFA or SIP circuits are to be configured, the B channels designated

for this purpose must also be specified here.

This is not necessary for reserved trunk circuits as the assignment is performed

based on the number of units (UNITS).

Only one circuit is possible for WAML.

This parameter can be omitted if UNITS=1.

Now you must reset the board.

RESET-BSSU:ADDRTYPE=PEN,LTU=<ltu>,SLOT=<slot>;