User's Manual

U3585-J-Z125-8-76 205
SM2 screen output SM2 information screens
SM2 information screens
The information screens are special in that they contain no monitored data, but provide
information on the monitoring run and on the SM2 status. These screens are only output if
explicitly requested by the user.
The first two screens listed are available in both the analysis subinterval and the
administration facility. The others are only available to privileged users in the administration
facility.
Displaying follow-up screens to information screens
All other entries have the same effect as ’+’.
The scroll commands can also be used to output the information screens of various hosts.
Note
It is not possible to page in batch and procedure modes. All follow-on screens are
always output.
MEASUREMENT STATUS Overview of all defined and active monitoring
programs
USER MEASURED OBJECTS Overview of user-monitored objects
DEFINED PARAMETER Overview of the monitoring parameters and
monitored objects defined for the individual
monitoring programs
ACTIVE PARAMETER Overview of the monitoring parameters and
monitored objects defined for the individual
monitoring programs
STATUS TABLE Status of the SM2 system tasks and of the
subsystems used by SM2
SELECTED HOSTS Overview of the hosts selected using the SELECT-
HOSTS statement
Entry Meaning
' +' or key
[K3] or [DUE Page forward
' -' or key
[K1] Page backward (if you page backward from the first page,
the first page is output again)
' - -' Page back to the first page
' END' Terminate output of follow-on screens