User Manual

Parameters

List of Parameters

1-98

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Sets the setpoint for the input signals in the digital input simulation mode.

Dependency: The simulation of a digital input is selected using p0795.

Refer to: p0795

Notice: To the terminal designation:

The first designation is valid for CU320, the second for CU310.

Note: This parameter is not saved when data is backed up (p0971).

AI: Analog Input

DI: Digital Input

T: Terminal

Description: Sets the simulation mode for the analog inputs.

Value: 0: No simulation mode for analog input x

1: Simulation mode for analog input x

Index: [0] = AI0 (T. 3/4)

[1] = AI1 (T. 10/11)

[2] = AI2 (T. 50/51)

[3] = AI3 (T. 52/53)

Dependency: The setpoint for the input voltage is specified via p0798.

Refer to: p0798

Note: This parameter is not saved when data is backed up (p0971).

AI: Analog Input

p0796 CU digital inputs simulation mode setpoint / CU DI simul setp

Access level: 3 Calculated: - Data type: Unsigned32

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - 0000 0000 0000 0000 bin

Bit field: Bit Signal name 1 signal 0 signal FP

00 DI 0 (T. 5) High Low -

01 DI 1 (T. 6) High Low -

02 DI 2 (T. 7) High Low -

03 DI 3 (T. 8) High Low -

04 DI 4 (T. 16) High Low -

05 DI 5 (T. 17) High Low -

11 DI 11 (T. 3, 4) AI 0 High Low -

12 DI 12 (T. 10, 11) AI 1 High Low -

p0797[0...3] CU analog inputs simulation mode / CU AI sim_mode

Access level: 3 Calculated: - Data type: Integer16

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0 1 0