User Manual

List of Parameters
Parameters
1-469
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011
Description: Displays the relevant setpoint at the multi-zone control output.
Description: Sets the signal source for the day/night multi-zone control switchover.
Description: Sets the signal source for the multi-zone control actual values.
Description: Displays the relevant actual value at the multi-zone control output.
r31024 CO: Multi-zone control setpoint output / Zone_ctrl set outp
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- [%] - [%] - [%]
p31025 BI: Multi-zone control day/night switchover / Zone_ctl day_night
Access level: 2 Calculated: - Data type: U32 / Binary
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 0
p31026[0...2] CI: Multi-zone control actual-value input / Zon_ctrl act inp
Access level: 2 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: T Scaling: PERCENT Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 0
r31027 CO: Multi-zone control actual-value output / Zon_ctrl act outp
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- [%] - [%] - [%]