User Manual

List of Parameters
Parameters
1-395
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011
Description: Sets the ramp-up and ramp-down time for the maximum and minimum limit (p11291, p11292) of the free technol-
ogy controller 2.
Dependency: Refer to: p11291, p11292
Note: The ramp-up/ramp-down times are referred to 100%.
Description: Display and connector output for the output signal of the free technology controller 2.
Description: Sets the signal source for the maximum limit of the free technology controller 2.
Dependency: Refer to: p11291
Description: Sets the signal source for the minimum limit of the free technology controller 2.
Dependency: Refer to: p11292
Description: Sets the signal source for the limit offset of the free technology controller 2.
p11293 Free tec_ctrl 2 limit ramp-up/ramp-down time / Ftec2 lim r-u/r-dn
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
0.00 [s] 100.00 [s] 1.00 [s]
r11294 CO: Free tec_ctrl 2 output signal / Ftec2 out_sig
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- [%] - [%] - [%]
p11297 CI: Free tec_ctrl 2 limit maximum signal source / Ftec2 lim max s_s
Access level: 3 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: U, T Scaling: PERCENT Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 11291[0]
p11298 CI: Free tec_ctrl 2 limit minimum signal source / Ftec2 lim min s_s
Access level: 3 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: U, T Scaling: PERCENT Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 11292[0]
p11299 CI: Free tec_ctrl 2 limit offset signal source / Ftec2 lim offs
Access level: 3 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: U, T Scaling: PERCENT Data set: -
Units group: - Unit selection: -
Min Max Factory setting
- - 0