User Manual

List of Parameters
Parameters
1-387
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011
Description: Sets the upper limit for the actual value signal of the free technology controller 1.
Dependency: Refer to: p11164
Description: Sets the lower limit for the actual value signal of the free technology controller 1.
Dependency: Refer to: p11164
Description: Sets the inversion of the actual value signal of the free technology controller 1.
Value: 0: No inversion
1: Inversion
Description: Display and connector output for the actual value after the limiter of the free technology controller 1.
Description: Display and connector output for the system deviation of the free technology controller 1.
p11167 Free tec_ctrl 1 actual value upper limit / Ftec1 act v up lim
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: PERCENT Data set: -
Units group: 9_3 Unit selection: p11126
Min Max Factory setting
-200.00 [%] 200.00 [%] 100.00 [%]
p11168 Free tec_ctrl 1 actual value lower limit / Ftec1 act v lo lim
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: PERCENT Data set: -
Units group: 9_3 Unit selection: p11126
Min Max Factory setting
-200.00 [%] 200.00 [%] -100.00 [%]
p11171 Free tec_ctrl 1 actual value inversion / Ftec1 act v inv
Access level: 3 Calculated: - Data type: Integer16
Can be changed: T Scaling: - Data set: -
Units group: - Unit selection: -
Min Max Factory setting
0 1 0
r11172 CO: Free tec_ctrl 1 actual value after limiter / Ftec1 act v af lim
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Data set: -
Units group: 9_3 Unit selection: p11126
Min Max Factory setting
- [%] - [%] - [%]
r11173 CO: Free tec_ctrl 1 system deviation / Ftec1 sys dev
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Data set: -
Units group: 9_3 Unit selection: p11126
Min Max Factory setting
- [%] - [%] - [%]