User Manual

List of Parameters

Parameters

1-33

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Displays supplementary control word.

Note: The following control bits are displayed in r0055:

Bit 00: r1198 Bit 0

Bit 01: r1198 Bit 1

Bit 02: r1198 Bit 2

Bit 03: r1198 Bit 3

Bit 04: r0837 Bit 0

Bit 05: r0837 Bit 1

Bit 08: r2349 Bit 0 (negated)

Bit 09: r1239 Bit 11

Bit 11: r1406 Bit 11

Bit 12: r1406 Bit 12

Bit 13: r2138 Bit 13

Bit 15: r0836 Bit 1

r0055.0...15 CO/BO: Supplementary control word / Suppl STW

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Fixed setp bit 0 Yes No -

01 Fixed setp bit 1 Yes No -

02 Fixed setp bit 2 Yes No -

03 Fixed setp bit 3 Yes No -

04 DDS select. bit 0 Yes No -

05 DDS select. bit 1 Yes No -

08 Technology controller enable Yes No -

09 DC braking enable Yes No -

11 Droop enable Yes No -

12 Torque control active Yes No -

13 External fault 1 (F07860) No Yes -

15 CDS bit 1 Yes No -