User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 Control Units CU230P-2 Parameter Manual

311

312

313

314

315

316

317

318

319

320

Parameters

List of Parameters

1-320

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Sets the operating mode for the "Hibernation" function.

Value: 0: Hibernation inhibited

1: Hibernation active

Dependency: Refer to: p2200, p2251

Refer to: A07325

Caution: When this function is active, the motor can start again automatically.

Note: When the "hibernation" function (p2398 = 1) is activated, its behavior is defined as to whether the technology con-

troller is additionally switched in (closed-loop) or switched out (open-loop).

The technology controller is enabled via binector input p2200 and its mode is set in p2251.

p2200 = 0, p2251 = 0, 1:

Hibernation operates without technology controller (open-loop)

p2200 = 1, p2251 = 0:

Hibernation operates with technology controller (closed-loop)

p2200 = 1, p2251 = 1:

Hibernation operates without technology controller (open-loop) as its output is only used as supplementary setpoint

and not as main setpoint.

Description: Displays the status word for the "Hibernation" function.

Dependency: Refer to: p2398

Refer to: A07325

p2398 Hibernation operating mode / Hib op_mode

Access level: 3 Calculated: - Data type: Integer16

Can be changed: T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0 1 0

r2399.0...8 CO/BO: Hibernation status word / Hib ZSW

Access level: 3 Calculated: - Data type: Unsigned32

Can be changed: - Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Hibernation enabled (p2398 <> 0) Yes No -

01 Hibernation active Yes No -

02 Hibernation delay time active Yes No -

03 Hibernation boost active Yes No -

04 Hibernation motor powered down Yes No -

05 Hibernation motor powered down cyclic

restart active

Yes No -

06 Hibernation motor restarts Yes No -

07 Hibernation supplies total setpoint for ramp-

function generator

Yes No -

08 Hibernation bypasses ramp-fct generator in

setpoint channel

Yes No -