User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 Control Units CU230P-2 Parameter Manual

311

312

313

314

315

316

317

318

319

320

List of Parameters

Parameters

1-315

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Sets the speed for the main drive, which is approached directly after an external motor has been connected or dis-

connected (staging/de-staging).

The parameter value refers to the maximum speed (p1082).

Description: Displays the status word for the staging function.

Description: Displays the operating hours for the external motors.

The display can only be reset to zero.

Index: [0] = Motor 1

[1] = Motor 2

[2] = Motor 3

Description: Time limit for the continuous operation of external motors.

Continuous operation is measured starting from when a motor is connected to the line voltage. It ends when a

motor is disconnected from the line.

p2378 Staging/De-staging speed / Stag/Destag speed

Access level: 3 Calculated: - Data type: FloatingPoint32

Can be changed: T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0.0 [%] 100.0 [%] 50.0 [%]

r2379.0...7 CO/BO: Staging status word / Staging ZSW

Access level: 3 Calculated: - Data type: Unsigned32

Can be changed: - Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Start external motor 1 Yes No -

01 Start external motor 2 Yes No -

02 Start external motor 3 Yes No -

03 Staging enabled Yes No -

04 Staging/De-staging active Yes No -

05 All motors active Yes No -

06 AutoChange not possible Yes No -

07 Staging alarm active Yes No -

p2380[0...2] Staging operating hours / Staging op_hrs

Access level: 3 Calculated: - Data type: FloatingPoint32

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0.0 [h] 340.28235E36 [h] 0.0 [h]

p2381 Staging time limit for continuous operation / Stag t_max cont

Access level: 3 Calculated: - Data type: FloatingPoint32

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0.1 [h] 100000.0 [h] 24.0 [h]