User Manual

Parameters

List of Parameters

1-276

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Sets the acknowledge mode for selected fault.

Value: 1: Acknowledgment only using POWER ON

2: Ack IMMEDIATELY after the fault cause has been removed

Dependency: Selects the faults and sets the required acknowledge mode realized under the same index

Refer to: p2126

Notice: It is not possible to re-parameterize the acknowledge mode of a fault in the following cases:

- if there is no existing fault number.

- the message type is not "fault" (F).

- when a fault is present.

Note: The acknowledge mode can only be changed for faults with the appropriate identification.

Example:

F12345 and acknowledge mode = IMMEDIATE (POWER ON)

--> The acknowledge mode can be changed from IMMEDIATELY to POWER ON.

Description: Selects faults or alarms which can be used as trigger.

Dependency: Refer to: r2129

p2127[0...19] Sets acknowledgement mode / Acknowledge mode

Access level: 3 Calculated: - Data type: Integer16

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

1 2 1

p2128[0...15] Selecting fault/alarm code for trigger / Message trigger

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0 65535 0