User Manual

Parameters

List of Parameters

1-268

SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 06/2011

Description: Sets the signal source for the connector-binector converter.

A PZD receive word can be selected as signal source. The signals are available to be serially passed-on (intercon-

nection).

Dependency: Refer to: r2094, r2095

Note: From the signal source set via the connector input, the corresponding lower 16 bits are converted.

p2099[0...1] together with r2094.0...15 and r2095.0...15 forms two connector-binector converters:

Connector input p2099[0] to binector output in r2094.0...15

Connector input p2099[1] to binector output in r2095.0...15

Description: Selects the faults for which the fault response should be changed

Dependency: The fault is selected and the required response is set under the same index.

Refer to: p2101

Notice: For the following cases, it is not possible to re-parameterize the fault response to a fault:

- if there is no existing fault number.

- the message type is not "fault" (F).

- when a fault is present.

p2099[0...1] CI: Connector-binector converter signal source / Con/bin S_src

Access level: 3 Calculated: - Data type: U32 / Integer16

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

- - 0

p2100[0...19] Setting the fault number for fault response / F_no F response

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: U, T Scaling: - Data set: -

Units group: - Unit selection: -

Min Max Factory setting

0 65535 0