User Manual

Parameters
Overview of parameters
1-8
© Siemens AG 2008 - 2013 All Rights Reserved
SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013
1.1 Overview of parameters
1.1.1 Explanation of the parameter list
Basic structure of parameter descriptions
The data in the following example has been chosen at random. The table below
contains all the information that can be included in a parameter description. Some
of the information is optional.
The parameter list (See Section 1.2) is structured as follows:
The individual pieces of information are described in detail below.
- - - - - - - - - - - - - - - - - - - - Start of example - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Description: Text
Values: 0: Name and meaning of value 0
1: Name and meaning of value 1
2: Name and meaning of value 2
etc.
Recommenda-
tion:
Text
Index: [0] = Name and meaning of index 0
[1] = Name and meaning of index 1
[2] = Name and meaning of index 2
etc.
Dependency: Text
See also: pxxxx, rxxxx
See also: Fxxxxx, Axxxxx
Note: Information which might be useful.
- - - - - - - - - - - - - - - - - - - - End of example - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
pxxxx[0...n] BICO: Long parameter name / short parameter name
CU/PM variants Access level: 3 Calculated: p0340 = 1 Data type: FloatingPoint32
Changeable: C(x), U, T Scaling: p2002 Dyn. index: CDS, p0170
Unit group: 6_2 Unit selection: p0505 Function diagram: 8070
Min Max Factory setting
0.00 [Nm] 10.00 [Nm] 0.00 [Nm]
Bit array: Bit Signal name 1 signal 0 signal FP
00 Name and meaning of bit 0 Yes No 8060
01 Name and meaning of bit 1 Yes No -
02 Name and meaning of bit 2 Yes No 8052
etc.
Danger: Warning: Caution: Safety notices with a warning triangle
Caution: Notice: Safety notices without a warning triangle