User Manual

Quick commissioning (p0010 = 1)
Parameters
1-489
© Siemens AG 2008 - 2013 All Rights Reserved
SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013
1.6 Quick commissioning (p0010 = 1)
The parameters required for the quick commissioning (p0010 = 1) are shown in Table 1-10:
.
Table 1-10 Quick commissioning (p0010 = 1)
Par. no. Name Access level Change-
able
p0010 Drive, commissioning parameter filter 1 C(1)T
p0015 Macro drive unit 1 C(1)
p0100 IEC/NEMA motor standard 1 C(1)
p0205 Power unit application 1 C(1,2)
p0230 Drive filter type, motor side 1 C(1,2)
p0300: Motor type selection 2 C(1,3)
p0301 Motor code number selection 2 C(1,3)
p0304 Rated motor voltage 1 C(1,3)
p0305 Rated motor current 1 C(1,3)
p0306 Number of motors connected in parallel: 1 C(1,3)
p0307 Rated motor power 1 C(1,3)
p0308 Rated motor power factor 1 C(1,3)
p0309 Rated motor efficiency 1 C(1,3)
p0310 Rated motor frequency 1 C(1,3)
p0311 Rated motor speed 1 C(1,3)
p0314 Motor pole pair number 4 C(1,3)
p0316 Motor torque constant 3 C(1,3)UT
p0322 Maximum motor speed 1 C(1,3)
p0323 Maximum motor current 1 C(1,3)
p0335 Motor cooling type 2 C(1,3)T
p0500 Technology application 4 PM230
PM330
C(1,5)T
p0500 Technology application 2 PM240
PM250
PM260, PM330
C(1,5)T
p0640 Current limit 2 C(1,3)UT
p0922 PROFIdrive telegram selection 1 C(1)T
p0970 Reset drive parameters 1 C(1,30)
p1080 Minimum speed 1 C(1)T
p1082 Maximum speed 1 C(1)T
p1120 Ramp-function generator ramp-up time 1 C(1)UT
p1121 Ramp-function generator ramp-down time 1 C(1)UT