User Manual

List of parameters

Parameters

1-435

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

Description: Setting parameter for the run sequence of instance NSW 1 within the run-time group set in p20226.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantity X of instance LIM 0 of the limiter.

Description: Setting parameter for the upper limit value LU of instance LIM 0 of the limiter.

Description: Setting parameter for the lower limit value LL of instance LIM 0 of the limiter.

Description: Display parameter for the limited output quantity Y of instance LIM 0 of the limiter.

Description: Display parameter of instance LIM 0 of limiter QU (upper limit reached), i.e. QU = 1 for X >= LU.

p20227 NSW 1 run sequence / NSW 1 RunSeq

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: T Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 7250

Min Max Factory setting

0 32000 620

p20228 CI: LIM 0 input X / LIM 0 input X

Access level: 3 Calculated: - Data type: U32 / FloatingPoint32

Can be changed: T Scaling: PERCENT Dyn. index: -