User Manual

List of parameters

Parameters

1-391

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

Description: Sets the time constant for the differentiation (D component) of the free technology controller 2.

Note: Value = 0: Differentiation is de-activated.

Description: Sets the proportional gain (P component) of the free technology controller 2.

Note: Value = 0: The proportional gain is de-activated.

Description: Sets the integral time (I component, integrating time constant) of the free technology controller 2.

Note: Value = 0: The integral time is disabled.

If the parameter is set to zero during operation, the I component retains its most recent value.

Description: Sets the maximum limit of the free technology controller 2.

Dependency: Refer to: p11292

Note: The maximum limit must always be greater than the minimum limit (p11291 > p11292).

Description: Sets the minimum limit of the free technology controller 2.

Dependency: Refer to: p11291

Note: The maximum limit must always be greater than the minimum limit (p11291 > p11292).

p11274 Free tec_ctrl 2 differentiation time constant / Ftec2 D comp T

Access level: 2 Calculated: - Data type: FloatingPoint32

Can be changed: U, T Scaling: - Dyn. index: -