User Manual

List of parameters
Parameters
1-389
© Siemens AG 2008 - 2013 All Rights Reserved
SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013
Description: Sets the ramp-up time for the free technology controller 2.
Dependency: Refer to: p11258
Note: The ramp-up time is referred to 100 %.
Description: Sets the ramp-down time of the free technology controller 2.
Dependency: Refer to: p11257
Note: The ramp-down time is referred to 100 %.
Description: Display and connector output for the setpoint after the ramp-function generator of the free technology controller 2.
Description: Sets the signal source for the actual value of the free technology controller 2.
Description: Sets the smoothing time constant (PT1) for the actual value of the free technology controller 2.
p11257 Free tec_ctrl 2 setpoint ramp-up time / Ftec2 setp t_r-up
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7030
Min Max Factory setting
0.00 [s] 650.00 [s] 1.00 [s]
p11258 Free tec_ctrl 2 setpoint ramp-down time / Ftec2 setp t_r-dn
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7030
Min Max Factory setting
0.00 [s] 650.00 [s] 1.00 [s]
r11260 CO: Free tec_ctrl 2 setpoint after ramp-function generator / Ftec2 setp aft RFG
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Dyn. index: -
Units group: 9_4 Unit selection: p11226 Func. diagram: 7030
Min Max Factory setting
- [%] - [%] - [%]
p11264 CI: Free tec_ctrl 2 actual value signal source / Ftec2 act v s_s
Access level: 2 Calculated: - Data type: U32 / FloatingPoint32
Can be changed: U, T Scaling: PERCENT Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7030
Min Max Factory setting
- - 0
p11265 Free tec_ctrl 2 actual value smoothing time constant / Ftec2 act v T
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7030
Min Max Factory setting
0.00 [s] 60.00 [s] 0.00 [s]