User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 Control Units CU230P-2 Parameter Manual

101

102

103

104

105

106

107

108

109

110

Parameters

List of parameters

1-106

SINAMICS G120 CU230P-2 Control Units List Manual (LH9), 01/2013

Note: Re bit 02:

A data set changeover is delayed by the time required for the internal parameter calculation.

Re bit 04:

A data set changeover is only carried out when the armature short circuit is not activated.

Re bit 05:

A data set changeover is only carried out when pole position identification is not running.

Re bit 07:

A data set changeover is only carried out when rotating measurement is not running.

Re bit 08:

A data set changeover is only carried out when motor data identification is not running.

Description: Displays the command data set (CDS) selected via the binector input.

Dependency: Refer to: r0050, p0810, p0811

Note: Command data sets are selected via binector input p0810 and following.

The currently effective command data set is displayed in r0050.

Description: Displays the drive data set (DDS) selected via the binector input.

Dependency: Refer to: r0051, p0820, p0821

Note: Drive data sets are selected via binector input p0820 and following.

The currently effective drive data set is displayed in r0051.

If there is only one data set, then a value of 0 is displayed in this parameter and not the selection via binector inputs.

Bit field: Bit Signal name 1 signal 0 signal FP

02 Internal parameter calculation active Yes No -

04 Armature short circuit active Yes No -

05 Identification running Yes No -

07 Rotating measurement running Yes No -

08 Motor data identification running Yes No -

r0836.0...1 CO/BO: Command Data Set CDS selected / CDS selected

Access level: 3 Calculated: - Data type: Unsigned8

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 1530, 8560

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 CDS selection bit 0 ON OFF -

01 CDS selection bit 1 ON OFF -

r0837.0...1 CO/BO: Drive Data Set DDS selected / DDS selected

Access level: 3 Calculated: - Data type: Unsigned8

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 8565

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 DDS selection bit 0 ON OFF -

01 DDS selection bit 1 ON OFF -