User Manual

SINAMICS G120 CU230P-2 Control Units
List Manual (LH9), 04/2014, A5E33838102B AA
491
2 Parameters
2.6 Quick commissioning (p0010 = 1)
If p0010 = 1 is selected, p0003 (user access level) can be used to select the parameters that
are to be accessed.
At the end of the quick commissioning, set p3900 = 1 to perform the required motor
calculations and reset all other parameters (not included in p0010 = 1) to their default settings.
p1500 Torque setpoint selection 2 C(1)T
p1900 Motor data identification and rotating measurement 2 C(1)T
p3900 Completion of quick commissioning 1 C(1)
Note
This only applies for the quick commissioning.
Table 2-10 Quick commissioning (p0010 = 1), continued
Par. no. Name Access level Changeable