User Manual

SINAMICS G120 CU230P-2 Control Units
List Manual (LH9), 04/2014, A5E33838102B AA
391
2 Parameters
2.2 List of parameters
Description: Display and connector output for the system deviation of the free technology controller 1.
Description: Sets the time constant for the differentiation (D component) of the free technology controller 1.
Note: Value = 0: Differentiation is de-activated.
Description: Sets the proportional gain (P component) of the free technology controller 1.
Note: Value = 0: The proportional gain is de-activated.
Description: Sets the integral time (I component, integrating time constant) of the free technology controller 1.
Note: Value = 0: The integral time is disabled.
If the parameter is set to zero during operation, the I component retains its most recent value.
Description: Sets the maximum limit of the free technology controller 1.
Dependency: Refer to: p11192
Note: The maximum limit must always be greater than the minimum limit (p11191 > p11192).
r11173 CO: Free tec_ctrl 1 system deviation / Ftec1 sys dev
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: - Scaling: PERCENT Dyn. index: -
Units group: 9_3 Unit selection: p11126 Func. diagram: 7030
Min Max Factory setting
- [%] - [%] - [%]
p11174 Free tec_ctrl 1 differentiation time constant / Ftec1 D comp T
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7030
Min Max Factory setting
0.000 [s] 60.000 [s] 0.000 [s]
p11180 Free tec_ctrl 1 proportional gain / Ftec1 Kp
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7030
Min Max Factory setting
0.000 1000.000 1.000
p11185 Free tec_ctrl 1 integral time / Ftec1 Tn
Access level: 2 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: - Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7030
Min Max Factory setting
0.000 [s] 10000.000 [s] 30.000 [s]
p11191 CO: Free tec_ctrl 1 limit maximum / Ftec1 lim max
Access level: 3 Calculated: - Data type: FloatingPoint32
Can be changed: U, T Scaling: PERCENT Dyn. index: -
Units group: - Unit selection: - Func. diagram: 7030
Min Max Factory setting
-200.00 [%] 200.00 [%] 100.00 [%]