User Manual

SINAMICS G120 CU230P-2 Control Units

List Manual (LH9), 04/2014, A5E33838102B AA

387

2 Parameters

2.2 List of parameters

Description: Sets the signal source for the maximum limit of the free technology controller 0.

Dependency: Refer to: p11091

Description: Sets the signal source for the minimum limit of the free technology controller 0.

Dependency: Refer to: p11092

Description: Sets the signal source for the limit offset of the free technology controller 0.

Description: Sets the signal source to switch in/switch out the free technology controller 1.

1 signal: The technology controller is switched in.

0 signal: The technology controller is switched out.

Description: Sets the unit for the parameters of the free technology controller 1.

Value: 1: %

2: 1 referred no dimensions

3: bar

4: °C

5: Pa

6: ltr/s

7: m³/s

8: ltr/min

9: m³/min

10: ltr/h

11: m³/h

p11097 CI: Free tec_ctrl 0 limit maximum signal source / Ftec0 lim max s_s

Access level: 3 Calculated: - Data type: U32 / FloatingPoint32

Can be changed: U, T Scaling: PERCENT Dyn. index: -