User Manual

SINAMICS G120 CU230P-2 Control Units

List Manual (LH9), 04/2014, A5E33838102B AA

373

2 Parameters

2.2 List of parameters

Value: 0: No function

1: Reserved

2: Save and activate configuration

3: Delete configuration

Notice: When the DHCP mode is active (p8924 > 0), then PROFINET communication via this interface is no longer possible!

However, the interface can be used by the STARTER/SCOUT commissioning tool.

Note: Re p8925 = 2:

The interface configuration (p8920 and following) is saved and activated after the next POWER ON.

Re p8925 = 3:

The factory setting of the interface configuration is loaded after the next POWER ON.

Description: Displays the active station name for the onboard PROFINET interface on the Control Unit.

Description: Displays the active IP address for the onboard PROFINET interface on the Control Unit.

Description: Displays the active default gateway for the onboard PROFINET interface on the Control Unit.

Description: Displays the active subnet mask for the onboard PROFINET interface on the Control Unit.

Description: Displays the active DHCP mode for the onboard PROFINET interface on the Control Unit.

Notice: When the DHCP mode is active (parameter value greater than 0), PROFINET communication via this interface is no

longer possible! However, the interface can be used for commissioning tool such as STARTER or SCOUT.

r8930[0...239] PN Name of Station active / PN Name Stat act

CU230P-2_PN Access level: 3 Calculated: - Data type: Unsigned8