Specifications

AT Command Set for L55 Platform 2003-11-21
Copyright  Siemens AG 2003 All Rights Reserved Page 82 of 131
2.3.11.17 AT+FMFR
AT+FMFR Request Manufacturer Identification
Read command
AT+FMFR?
Used for FAX class 2 only
Send the model identification to the TA.
Response
Siemens
OK
2.3.11.18 AT+FOPT
AT+FOPT Set bit order independently
Write command
AT+FOPT=<opt>
Used for FAX class 2 only
Model-specific command to set bit order independently of the
understanding which is "mirrored" and which is direct.
Parameter:
<opt>
0 non-standard
1 standard
Response
OK
2.3.11.19 AT+FPHCTO
AT+FPHCTO DTE Phase C Response Timeout
Read command
AT+FPHCTO?
Used for FAX class 2 only
Send the model identification to the TA.
Response
<tout>
OK/ERROR
Write command
AT+FPHCTO=<tout>
Used for FAX class 2 only
Model-specific command to set bit order independently of the
understanding which is "mirrored" and which is direct.
Parameter:
<tout> 0...255 determines how long the DCE will wait for a
command after reaching the end of data when
transmitting in Phase C. When time-out is
reached, the DCE assumes that there are no
more pages or documents to send.
Time-out value in 100ms units.
30 default
Response
<tout>
OK/ERROR