Specifications

AT Command Set for L55 Platform 2003-11-21

2.3.11 Fax commands

The following commands can be used for FAX transmission. If the ME is acting as a FAX modem to a

PC-based application, it is necessary to select the appropriate service class (FAX class) provided by

the ME. The ME reports its FAX service class capabilities, both the current setting and the range of

services available, via the AT+FCLASS command.

Note: According to EIA/TIA-592-A, the Error Correcting Mode (ECM) should not be used when

sending FAXes over GSM.

+FCLASS parameter Service Class Reference, Standard

0 e.g. TIA/EIA-602 or ITU V.25ter

1 Service Class 1 EIA/TIA-578-A

2 Vendor-specific this document and EIA PN-2388 (draft)

The following FAX commands are dummy commands. Invoking these commands will not cause

ERROR result codes, but these commands have no functionality either:

Command Meaning

AT+FAA Auto Answer mode

AT+FECM Error Correction Mode control

AT+FLNFC Page Length format conversion

AT+FLPL Indicate document available for polling

AT+FMINSP Minimum Phase C speed

AT+FRBC Phase C data receive byte count

AT+FREL Phase C received EOL alignment

AT+FSPL Enable polling

AT+FTBC Phase C data transmit byte count

AT+FWDFC Page width format conversion

Table 2-9: List of dummy FAX commands