Operating instructions

04/02 1 Parameters

MICROMASTER 420 Parameter List

6SE6400-5BA00-0BP0

1.2 Quick commissioning (P0010=1)

The following parameters are necesarry for quick commissioning (P0010=1).

No Name Access level Cstat

P0100 Europe / North America 1 C

P0300 Select motor type 2 C

P0304 Motor voltage rating 1 C

P0305 Motor current rating 1 C

P0307 Motor power rating 1 C

P0308 Motor cosPhi rating 2 C

P0309 Motor efficiency rating 2 C

P0310 Motor frequency rating 1 C

P0311 Motor speed rating 1 C

P0320 Motor magnetizing current 3 CT

P0335 Motor cooling 2 CT

P0640 Motor overload factor [%] 2 CUT

P0700 Selection of command source 1 CT

P1000 Selection of frequency setpoint 1 CT

P1080 Min. speed 1 CUT

P1082 Max. speed 1 CT

P1120 Ramp-up time 1 CUT

P1121 Ramp-down time 1 CUT

P1135 OFF3 ramp-down time 2 CUT

P1300 Control mode 2 CT

P1910 Select motor data identification 2 CT

P3900 End of quick commissioning 1 C

When P0010=1 is chosen, P0003 (user access level) can be used to select the

parameters to be accessed. This parameter also allows selection of a user-defined

parameter list for quick commissioning.

At the end of the quick commissioning sequence, set P3900 = 1 to carry out the

necessary motor calculations and clear all other parameters (not included in P0010=1)

to their default settings.

Note

This applies only in Quick Commissioning mode.

Reset to Factory default

To reset all parameters to the factory default settings; the following parameters should

be set as follows:

Set P0010=30.

Set P0970=1.

Note

The reset process takes approximately 10 seconds to complete. Reset to Factory

default