Operating instructions

04/02 1 Parameters
MICROMASTER 420 Parameter List
6SE6400-5BA00-0BP0
53
P1056 BI: Enable JOG left
Min: 0:0
CStat: CT Datatype: U32 Unit: - Def: 0:0
P-Group: COMMANDS Active: first confirm QuickComm. No Max: 4000:0
Defines source of JOG left when P0719 = 0 (remote selection of command/setpoint source).
Common Settings:
722.0 = Digital input 1 (requires P0701 to be set to 99, BICO)
722.1 = Digital input 2 (requires P0702 to be set to 99, BICO)
722.2 = Digital input 3 (requires P0703 to be set to 99, BICO)
722.3 = Digital input 4 (via analog input, requires P0704 to be set to 99)
19.9 = JOG left via BOP
P1058 JOG frequency right Min: 0.00
CStat: CUT Datatype: Float Unit: Hz Def: 5.00
P-Group: SETPOINT Active: Immediately QuickComm. No Max: 650.00
Jogging increases the motor speed by small amounts. The JOG buttons uses a non-latching switch on one
of the digital inputs to control the motor speed.
While JOG right is selected, this parameter determines the frequency at which the inverter will run.
JOG right
f
P1058
P1059
A0923 A0923
P1060 P1060 P1061
(0)
P1055
(0)
P1056
"1"
"0"
"1"
"0"
t
t
t
P1061
DIN
BOP
USS
BOP link
USS
COM link
CB
COM link
JOG left
Dependency:
P1060 and P1061 set up and down ramp times respectively for jogging.
P1059 JOG frequency left Min: 0.00
CStat: CUT Datatype: Float Unit: Hz Def: 5.00
P-Group: SETPOINT Active: Immediately QuickComm. No Max: 650.00
While JOG left is selected, this parameter determines the frequency at which the inverter will run.
Dependency:
P1060 and P1061 set up and down ramp times respectively for jogging.
Level:
3
Level:
2
Level:
2