Operating instructions

ManualsBrandsSiemens ManualsIndustrialMICROMASTER

MM420 Parameter List 04/02

MICROMASTER 420 Parameter List

14 6SE6400-5BA00-0BP0

r0019 CO/BO: BOP control word Min: -

Datatype: U16 Unit: - Def: -

P-Group: COMMANDS Max: -

Displays status of operator panel commands.

The settings below are used as the "source" codes for keypad control when connecting to BICO input

parameters.

Bitfields:

Bit00 ON/OFF1 0 NO

1 YES

Bit01 OFF2: Electrical stop 0 YES

1NO

Bit08 JOG right 0 NO

1 YES

Bit11 Reverse (setpoint inversion) 0 NO

1 YES

Bit13 Motor potentiometer MOP up 0 NO

1 YES

Bit14 Motor potentiometer MOP down 0 NO

1 YES

Note:

When BICO technology is used to allocate functions to panel buttons, this parameter displays the actual

status of the relevant command.

The following functions can be "connected" to individual buttons:

- ON/OFF1,

- OFF2,

- JOG,

- REVERSE,

- INCREASE,

- DECREASE

r0020 CO: Freq. setpoint before RFG Min: -

Datatype: Float Unit: Hz Def: -

P-Group: CONTROL Max: -

Displays actual frequency setpoint (output from ramp function generator).

r0021 CO: Act. frequency Min: -

Datatype: Float Unit: Hz Def: -

P-Group: CONTROL Max: -

Displays actual inverter output frequency (r0024) excluding slip compensation, resonance damping and

frequency limitation.

r0022 Act. filtered rotor speed Min: -

Datatype: Float Unit: 1/min Def: -

P-Group: CONTROL Max: -

Displays calculated rotor speed based on inverter output frequency [Hz] x 120 / number of poles.

Note:

This calculation makes no allowance for load-dependent slip.

r0024 CO: Act. output frequency Min: -

Datatype: Float Unit: Hz Def: -

P-Group: CONTROL Max: -

Displays actual output frequency (slip compensation, resonance damping and frequency limitation are

included).

r0025 CO: Act. output voltage Min: -

Datatype: Float Unit: V Def: -

P-Group: CONTROL Max: -

Displays [rms] voltage applied to motor.

r0026 CO: Act. filtered DC-link volt. Min: -

Datatype: Float Unit: V Def: -

P-Group: INVERTER Max: -

Displays DC-link voltage.

r0027 CO: Act. output current Min: -

Datatype: Float Unit: A Def: -

P-Group: CONTROL Max: -

Displays [rms] value of motor current [A].

Level: