Operating instructions

5 System parameters Issue B1
MICROMASTER 420 Operating Instructions
60 6SE6400-5AA00-0BP0
Par. No. Parametername Default Acc WS QC
P2220[1] BI: Fixed PID setp. select Bit 0 0:0 3 CT -
P2221[1] BI: Fixed PID setp. select Bit 1 0:0 3 CT -
P2222[1] BI: Fixed PID setp. select Bit 2 0:0 3 CT -
P2235[1] BI: Enable PID-MOP (UP-cmd) 19:13 3 CT -
P2236[1] BI: Enable PID-MOP (DOWN-cmd) 19:14 3 CT -
Analogue I/O (P0004 = 8)
Par. No. Parametername Default Acc WS QC
r0750 Number of ADCs - 3 - -
r0751 CO/BO: Status word: ADC-channels - 4 - -
r0752[1] Act. input of ADC [V] - 2 - -
P0753[1] Smooth time ADC 3 3 CUT -
r0754[1] Act. ADC value after scaling [%] - 2 - -
r0755[1] CO: Act. ADC after scal. [4000h] - 2 - -
P0756[1] Type of ADC 0 2 CT -
P0757[1] Value x1 of ADC scaling 0 2 CUT -
P0758[1] Value y1 of ADC scaling 0.0 2 CUT -
P0759[1] Value x2 of ADC scaling 10 2 CUT -
P0760[1] Value y2 of ADC scaling 100.0 2 CUT -
P0761[1] Width of ADC deadband 0 2 CUT -
P0762[1] Delay for loss of signal action 10 3 CUT -
r0770 Number of DACs - 3 - -
P0771[1] CI: DAC 21:0 2 CUT -
P0773[1] Smooth time DAC 2 3 CUT -
r0774[1] Act. DAC value - 2 - -
r0776[1] Type of DAC 0 3 CT -
P0777[2] Value x1 of DAC scaling 0.0 2 CUT -
P0778[1] Value y1 of DAC scaling 0 2 CUT -
P0779[1] Value x2 of DAC scaling 100.0 2 CUT -
P0780[1] Value y2 of DAC scaling 20 2 CUT -
P0781[1] Width of DAC deadband 0 2 CUT -
Setpoint Channel and Ramp Generator (P0004 = 10)
Par. No. Parametername Default Acc WS QC
P1000[1] Selection of frequency setpoint 2 1 CT Q
P1001 Fixed frequency 1 0.00 2 CUT -
P1002 Fixed frequency 2 5.00 2 CUT -
P1003 Fixed frequency 3 10.00 2 CUT -
P1004 Fixed frequency 4 15.00 2 CUT -
P1005 Fixed frequency 5 20.00 2 CUT -
P1006 Fixed frequency 6 25.00 2 CUT -
P1007 Fixed frequency 7 30.00 2 CUT -
P1016 Fixed frequency mode - Bit 0 1 3 CT -
P1017 Fixed frequency mode - Bit 1 1 3 CT -
P1018 Fixed frequency mode - Bit 2 1 3 CT -