Operating instructions

3 Commissioning Issue B1
MICROMASTER 420 Operating Instructions
34 6SE6400-5AA00-0BP0
3.2 Commission modes
In the standard version, the MICROMASTER 420 is fitted with the Status Display
Panel (SDP) (see Figure 3-2) with which it is possible to use the inverter with the
pre-assigned factory settings for a large range of applications. If these factory
settings are not suitable, you can adapt them to suit your equipment conditions
using the Basic Operator Panel (BOP) (see Figure 3-2) or the Advanced Operator
Panel (AOP) (see Figure 3-2). The BOP and AOP are available as options. You
can also adjust the factory settings using the PC IBN tool "Drive Monitor" or
"STARTER“. This software is available on the CD ROM which comes with the
documentation of the unit.
SDP BOP AOP
Status Display Panel Basic Operator Panel Advanced Operator Panel
Figure 3-2 Panels available for the MICROMASTER 420 Inverter
For notes on replacing the operator panels please refer to the corresponding
annexes 0 to this manual.
NOTICE
The default (factory value) frequency setting can be altered by means of theDIP
switch under the SDP. The inverter is delivered as follows::
Ø DIP switch 2:
♦ Off position:
European defaults
(50 Hz, kW usw.)
♦ On position:
North American defaults
(60 Hz, hp usw.)
Ø DIP switch 1:
Not for customer use.
DIP switch for the
frequency setting
Figure 3-3 DIP switch