Specifications

MC35i AT Command Set
10.14 ATD*98#
s
m obil e
MC35i_ATC_V01.03 Page 254 of 444 5/7/04
Confidential / Released
10.14 ATD*98# Request GPRS IP service
Syntax
Command Description
This command causes the MT to perform whatever actions are necessary to establish a communication between
the TE and the external PDN.
The V.25ter 'D' (Dial) command causes the MT to enter the V.25ter online data state and, with the TE, to start
the layer 2 protocol.
GPRS attachment and PDP context activation procedures may take place prior to or during the PDP startup if
they have not already been performed using the
AT+CGATT and AT+CGACT commands. If the context to be used
is already activated, it will be deactivated first. This ensures that the right context parameters will be used (e.g.
QoS changes since the last context activation).
To confirm acceptance of the command before entering the V.25ter online data state command will respond with
CONNECT.
When the layer 2 protocol has terminated, either as a result of an orderly shut down of the PDP or an error, the
MT enters V.25ter command state and returns NO CARRIER.
Parameter Description
Parameter specifies a particular PDP context definition (see AT+CGDCONT command). If no context is specified,
an internal context 0 with default properties is used (see
AT+CGDCONT, AT+CGQREQ and AT+CGQMIN).
1...2
Notes
• If MC35i is in dedicated mode, command returns with "+CME ERROR: phone busy".
•
ATD is used as a standard V.25ter AT Command, too.
Exec Command
ATD*98[* <cid>]#
Response(s)
CONNECT
NO CARRIER
PIN ASC0 MUX1 MUX2 MUX3
% % % § §
Reference(s)
GSM 07.07
<cid>
(num)