Data Sheet for Product

ManualsBrandsSiemens Manuals3rd party integrationMicrotech 2000 Water Source Heat Pump, Point Map

Point Map

Rev. 3, February, 2002

Siemens Building Technologies, Inc. Page 1 of 4

Document No. 127-0017

Systems Integration

APOGEE

Open Processor with McQuay Microtech

Driver Point Map: Remote Monitoring and Control Panel

for Rooftop Units

Table 1. Remote Monitoring and Control Panel for Rooftop Units.

Point Type Description Range/Units

01 LAO Device Address —

02 LAO Application Number 5019

03 LDI Schedule Status Off/On

04 LAI Control Temperature Group 1 °F

05 LAI Control Temperature Group 2 °F

06 LAI Control Temperature Group 3 °F

07 LAI Control Temperature Group 4 °F

08 LAI Static Pressure Group 1 IWC

09 LAI Static Pressure Group 2 IWC

10 LAI Static Pressure Group 3 IWC

11 LAI Static Pressure Group 4 IWC

12 LAI Speed/Vane Position Group 1 0 – 100%

13 LAI Speed/Vane Position Group 2 0 – 100%

14 LAI Speed/Vane Position Group 3 0 – 100%

15 LAI Speed/Vane Position Group 4 0 – 100%

16 LAO Seconds 0 – 59

17 LAO Minutes 0 – 59

18 LAO Hours 0 – 23

19 LAO Day of Week 1 = Sunday, 7 = Saturday

20 LAO Date 1 – 31

21 LAO Month 1 – 12

22 LAO Year 0 – 99

continued on next page…

Summary of content (4 pages)

PAGE 1
Point Map Rev. 3, February, 2002 Systems Integration APOGEE¥ Open Processor with McQuay Microtech Driver Point Map: Remote Monitoring and Control Panel for Rooftop Units Table 1. Remote Monitoring and Control Panel for Rooftop Units.
PAGE 2
Table 1. Remote Monitoring and Control Panel for Rooftop Units. Point Type Description Range/Units 23 LAO Number of Rooftop Units. Number of rooftop units in network. Value used to determine if rooftop units are communicating. Rooftop units must have consecutive addresses starting with 1. 24 LAO Group Number for Unit 1. Rooftop units can be combined into groups 0 = Not Associated With Group for common control. 1 – 4 = Unit Number 25 LAO Group Number for Unit 2.
PAGE 3
Table 1. Remote Monitoring and Control Panel for Rooftop Units. Point Type Description 42 LAO Group 3 Pressure Calculation 0 = Minimum Static Pressure 1 = Maximum Static Pressure 2 = Average 43 LAO Group 3 Pressure Set Point 0 – 4 IWC 44 LDO Group 4 Control Temperature Choice. Control temperature set point indicates which temperature value to use as control temperature.
PAGE 4
Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as design improvements are introduced. Other product or company names mentioned herein may be the trademarks of their respective owners. © 2002 Siemens Building Technologies, Inc. Siemens Building Technologies, Inc. 1000 Deerfield Parkway Buffalo Grove, IL 60089-4513 U.S.A. Printed in the U.S.A. Document No.