Instruction manual

en Operating the appliance
6
Control panel model 2
Control panel
Setting the fan
Switching on the appliance
■ Press the # button.
The fan starts at setting ƒ.
■ Press the + or - button to change the fan strength.
Switching off
Press the # button.
Intensive setting
You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
Press the + button when the fan is at setting „.
The intensive setting2‚ is activated. Pressing the +
button again activates the intensive setting 2 ƒ.
After approx. six minutes, the electronics automatically
reduce the fan to a lower setting . If you want to end the
intensive setting before the preset time expires, press
the - button until the required fan setting is reached.
Boost function
The boost function is a short-term maximum power
setting which can be activated in any fan setting.
Press the & button. After approx. 20 seconds, the fan
switches back to the previously set fan setting.
Fan run-on time
Press the x button.
The fan continues to operate for a further 10 minutes,
and switches off automatically after this time. If the
lighting is switched on, it remains on.
Press the x button to end the fan run-on time early.
Lighting
The lighting can be switched on and off independently
of the fan.
Press the A button.
Setting the brightness
Press and hold the A button until the desired
brightness is reached.
Saturation display
When the metal mesh grease filters or the activated
carbon filter are saturated, a signal sounds for approx.
4 seconds after the fan is switched off.
In addition, the corresponding symbol appears in the
display:
■ Metal mesh grease filter:!
■ Activated carbon filter: "
If you have not yet done so, the metal mesh grease
filters should be cleaned or the activated carbon filter
changed now.
For instructions on how to clean the metal mesh grease
filters, please refer to the section Cleaning and
maintenance
.
While the saturation displays are flashing, they can be
reset. To do this, press the – button.
Switching over the display for circulating-air mode
For circulating-air mode, the electronic control display
must be switched over accordingly:
■ The extractor hood must be connected and switched
off.
■ Press the # and x buttons at the same time until
the
™" display for starter sets for circulating-air mode
or
the ’" display for CleanAir circulating air modules
lights up.
■ Repeatedly press the button combination to switch
the electronic control display back to exhaust air
mode (! display).
Audible signal
Switching on the acoustic signal
When the fan is switched off, press the # and + at the
same time for approx. three seconds. An
acknowledgement signal sounds.
Switching off the acoustic signal
Repeat the "Switching on the acoustic signal" process.
Explanation
#
Fan on/off
A
Light on/off/dimming
- Reduce the fan settings
+ Increase the fan settings/intensive setting 1, 2
&
Boost function (short-term maximum power)
x
Fan run-on time