Installation Instructions

Document No. 570-133
Installation Instructions
October 26, 2016
Siemens Industry, Inc. Page 3 of 9
3. Remove the controller from the static proof bag
and snap it into place on the mounting rail.
4. If the controller will be used with a field panel,
disconnect the field level network (FLN) trunk
from the field panel.
5. Wire the FLN trunk to the controller. After all
controllers are connected to the FLN, reconnect
the FLN trunk to the field panel.
6. If the controller requires Offboard Air Modules,
install them now following the appropriate
Installation Instructions (see Product Numbers ).
7. Connect the point wiring (see Wiring Diagram s).
CAUTION
DO Wiring – Each DO provides a
Normally Open (NO) terminal and a
Common (C) terminal.
To reduce noise and the potential
for ground loops, both connections
of a 24 Vac load must be wired
directly to the DO terminal on the
controller board.
Raccordement des sorties
numériques (DO) – chaque DO se
compose d’une borne normalement
ouverte (NO) et d’une borne
commune (C).
Afin de réduire les emissions
sonores et d’éviter de créer des
boucles de terre, les deux
connexions à une charge de 24 Vac
doivent être directement raccordées
à la borne DO sur la carte
contrôleur.
8.
For each Fast Acting Lab Electronic
Actuator, verify that the switches are set as
shown in Figure
Switch Settings for the Fast
Acting Lab Electronic Actuator
.
Supply
Exhaust
Switch Settings for the Fast Acting Lab Electronic
Actuator.
CAUTION
This actuator requires a maximum
of 20 VA, 24 Vac source.
DO NOT connect any other non-
isolated devices to the transformer
that powers the electronic actuator
or the hot water valve actuator.
Cet actionneur nécessite une
source d’alimentation maximale de
20 VA, 24 Vca.
NE PAS brancher de périphériques
non-isolés sur le transformateur qui
alimente l’actionneur ou l’actionneur
de la vanne d’eau chaude.
9.
Plug the room temperature sensor cable into
the RTS port.
10.
Connect the power trunk. DO NOT apply
power to the controller without first consulting
the specialist.