Installation Instructions

Document No. 537-760
Installation Instructions
Rev. 3, February, 2000
Information in this publication is based on current specifications. The company reserves the right to make changes in specifications and
models as design improvements are introduced. © 2000 Siemens Building Technologies, Inc.
Siemens Building Technologies, Inc.
Landis & Staefa Division
1000 Deerfield Parkway
Buffalo Grove, IL 60089-4513
U.S.A.
Document No.: 537-760
Printed in the U.S.A.
Page 3 of 3
5. Place the ODP onto the mounting bracket so
that the flange engages into the slot located
inside the top of the panel housing (Figure 5).
Figure 5. Placement of Panel on Mounting Plate.
6. Insert hex screw into the bottom tab of the
mounting plate to secure the bottom of the ODP
(Figure 5).
7. Apply the information label to the fume hood
as close to the ODP as possible (Figure 6).
Figure 6. Placement of Information Label.
The installation is complete.
Figure 7. Mounting Plate Dimensions.