Operating Instructions

Chapter 2 – Applications
Application 2900 Slave Mode
13
Siemens Industry, Inc. Owner's Manual 125-5094
Building Technologies 2015-11-04
Application 2900 Slave Mode
Application 2900 is the slave mode application for the Fume Hood Controller (see
Ordering Notes for product numbers). Slave mode is the default application that comes
up when power is first applied to the controller. Slave mode provides no control. Its
purpose is to allow the operator to perform equipment checkout before a control
application is put into effect and to set some basic controller parameters (CTLR
ADDRESS, APPLICATION, and so on).