User Manual

4 / 6
Siemens RF adapter plugs, dimming KRF961 CE1N2719en
Building Technologies 05.11.2008
Engineering and operating notes
• The KRF961 must be plugged into a power outlet
• The permissible environmental conditions must be observed
• Do not modify the device for outdoor use
• The KRF961 must not be exposed to drip water
• For Planning and Mounting Instructions on wireless devices of the Siemens
Synco living system, refer to Data Sheet CE1N2708en
The KRF961 is suited for use with all types of commercially available power outlets
(note type of outlet!).
For commissioning, the KRF961 must be plugged into a power outlet at the
location where it is used.
The device is protected against overheating and overloads.
In the case of overheating or overload, the device’s output is reduced.
Remedy: Check the connected load and ensure compliance with the
technical data specified below.
The KRF961 is maintenance-free.
In terms of disposal at the end of the product’s service life, the KRF961 is regarded
as electronic scrap conforming to the European Directive 2002/96/EC (WEEE) and
must not be disposed of together with domestic waste. Disposal must take place
through appropriate channels.
Local and currently valid legislation must be observed.
Warranty
Warranty with regard to application-related data is valid only when the KRF961 is
used in connection with the Siemens Synco living system.
When used with products of other manufacture, correct operation must be
ensured by the user. In that case, Siemens does not provide any service or
warranty.
Mounting location
Mounting
Commissioning
Protection against
overheating and
overloads
Maintenance
Disposal