User`s manual

SH-300 Text Panel
Page 52 of 103
Select “Indicator” under “Object” menu or click in the tool bar. Move the mouse to proper
place behind “Heating Unit 1” and click the left key of the mouse to confirm as in the following
diagram. And add two other indicators as the above.
Set the “Indicator” one by one.
The setting of the indicator for the heating unit 1 is listed as below: Address=M30,
Shape=Square, logic=positive;
The setting of the indicator for the heating unit 2 is listed as below: Address=M40,
Shape=Square, logic=positive;
The setting of the indicator for the heating unit 3 is listed as below: Address=M50,
Shape=Square, logic=positive.
5. Make Screen 4 “Motor Setting”
As stated above, create the Screen 4. The input the text “Target”, “Current”, “Motor”,
“Speed” in proper place in the screen as in the following diagram:
Select “Register” under “Object” menu or click in the tool bar. Move the mouse to proper
place under “Target” and click the left key of the mouse to confirm. Then set the parameter of
the register, Address=D80, Digits=5, Decimal=1, Mode=Dec. Select the “Set” check box as
shown in the following diagram: